Rear Suspension - Sherco ST Serie Manuel D'atelier

- To change the rear damper, it is
necessary to dismantle the fi lter box,
the rear mudguard and the muffl er to
access the upper anchorage. Also
loosen the anchorage from the group
of lower connecting rods and the
damper is free to be removed.
- The damper can also be removed
from below by loosening the upper
screw and dismantling the group of
connecting rods. The connecting rod is
forwarded. Check the condition of the
sleeves and the bearings and replace
them if necessary. Adequately grease
the parts before reassembling them.
❱❘
PARTS BREAKDOWN
154

REAR SUSPENSION

ST SERIES