Insert Spray Nozzles; Assemble Spray Gun And Hose; Initial Oil Fill - Westinghouse WPX2700 Mode D'emploi

INSERT SPRAY NOZZLES

Insert the colored nozzles into the corresponding holders
on the top of the pressure washer (WPX2700 shown).

ASSEMBLE SPRAY GUN AND HOSE

1. Install the spray lance on the spray gun. Tighten the
spray gun collar hand-tight. DO NOT over-tighten.
2. Install the high-pressure hose and tighten the collar. DO
NOT over-tighten.
3. Engage the trigger lock in the safe position.
Note: The trigger lock prevents the spray gun from being
triggered accidentally. Push the lock fully up to
engage it.
4. Select desired nozzle for application. Pull back the
quick-connect collar at the end of the spray lance. Insert
the nozzle then release the collar. Pull on the nozzle to
make sure it is secured.
5. Mount the spray gun in the gun holders.
6. Connect the high-pressure hose to the high pressure
outlet on the pump. DO NOT over-tighten.
Be careful to avoid cross-threading, which can cause the
hose to leak during use.

INITIAL OIL FILL

THIS UNIT HAS BEEN SHIPPED WITHOUT OIL. Do
not attempt to crank or start engine before it has been
properly serviced with recommended oil. Failure to add
engine oil before starting will result in serious engine
damage.
Use of 2-stroke/cycle oil or other unapproved oil types
can cause severe engine damage that is not covered
under warranty.
The included, recommended oil type for typical use is 10W-
30 engine oil. If running the pressure washer in extreme
temperatures, refer to the following chart.
1. On a level surface, remove the oil dipstick.
Note: There is an oil dipstick/filler neck on both sides of
the unit. Either can be used to check or add oil.
Westinghouse Outdoor Power Equipment, LLC | 9
ASSEMBLY
NOTICE
NOTICE
NOTICE