Fuel; Filling The Fuel Tank - Westinghouse WPX2700 Mode D'emploi

ASSEMBLY
2. Using the supplied oil and funnel tip, add oil into oil filler
neck.
Note: As residual oil from the factory may remain in
the engine, add the oil incrementally to prevent
overfilling the engine. See Engine Oil Level Check
in the Maintenance section.
3. Replace the oil dipstick and hand-tighten.

FUEL

Fire and explosion hazard. Never use a gasoline
container, gasoline tank, or any other fuel item that is
broken, cut, torn or damaged.
Fire and explosion hazard. Do not overfill fuel tank.
Fill only to the bottom of the filler neck. Overfilling may
cause fuel to spill onto engine causing a fire or explosion
hazard.
Fire and explosion hazard. Never refuel the pressure
washer while the engine is running. Always turn the
engine off and allow the pressure washer to cool for two
minutes before refueling.
Do not use E15 or E85 fuel in this
product.
damage caused by stale fuel or
the use of unapproved fuels (such
as E15 or E85 ethanol blends) is
not covered by warranty. Only use
unleaded gasoline containing up to
10% ethanol.
FUEL REQUIREMENTS
• CLEAN, FRESH, unleaded gasoline, 87–93 octane.
• Up to 10% ethanol (gasohol) is acceptable (where
available; non-ethanol fuel is recommended).
• DO NOT use E85 or E15.
• DO NOT use a gas oil mix.
• DO NOT modify the engine to run on alternate fuels.
• DO NOT fuel indoors.
• DO NOT create a spark or flame while fueling.
USING FUEL STABILIZER
Adding a fuel stabilizer (not included) extends the usable
life of fuel and helps prevent deposits from forming that
10 | Westinghouse Outdoor Power Equipment, LLC
NOTICE
Engine or
can clog the fuel system. Follow the manufacturer's
instructions for use.
Always mix the correct amount of fuel stabilizer to gasoline
in an approved gasoline container before fueling the
pressure washer. Run the pressure washer for two minutes
to allow the stabilizer to treat the entire fuel system.

FILLING THE FUEL TANK

1. Turn the pressure washer OFF and allow to cool for a
minimum of two minutes before fueling.
2. Place the pressure washer on level ground in a well
ventilated area.
3. Clean area around fuel cap and remove the cap slowly.
Only fill the tank from an approved gasoline container.
Make sure the gasoline container is internally clean and
in good condition to prevent fuel system contamination.
4. Slowly add the recommended fuel. Do not overfill. Fill
only to the top of the fuel screen filter visible in the filler
neck.
equipment
5. Install the fuel cap and tighten until a click is heard.
Fuel can damage paint and plastic. Use caution when
filling the fuel tank. Damage caused by spilled fuel is not
covered under warranty.
Clean the fuel screen filter of debris before and after
each fueling. Remove the fuel screen filter by slightly
compressing it while removing it from the fuel tank.
NOTICE
NOTICE
NOTICE