Osd Menu Startup; Direct Control Menu - Eneo TPD-62V2812P0A Guide D'installation Rapide

OSD menu startup

Press '●' (OSD menu Joy stick key) down for about 2 seconds to access the setup menu
mode.
MENU
1. EXPOSURE
2. LENS
3. FOCUS ASSIST
4. SCENE ENHANCE
5. 3D-NR
6. DAY/NIGHT
7. PICT ADJUST
8. SPECIAL
9. SYSTEM
A. EXIT

Direct control menu

MAIN
EXPOSURE
LENS
FOCUS ASSIST
SCENE ENHANCE
3D-NR
12
V3.xx
DC
NORMAL
MID
EXT
SAVE&EXIT
DEFAULT
-
DC
-
NORMAL
MID
DESCRIPTION
Sets SHUTTER MODE, BRIGHTNESS, SENS-UP and AGC.
Sets Lens types
Sets Focus Adjustments.
SCENE ENHANCE provides the several ways to enhance the video in the
various environments with the settings in NORMAL, WDR, D-WDR, BLC
and HLC.
NORMAL – Optimized for the normal indoor and outdoor in the
good lighting condition.
WDR – Improves the visibility for the high bright area and the darka-
rea by the double captures of image with LONG and SHORT exposures.
With WDR ON, the frame rate becomes half by the double captures.
WDR level can be selected from LOW, MID and HIGH. Care should be
taken to select this mode because video may lose its quality in some
environments by the over compensation.
CVBS video signal: Connecting 2nd video to CVBS port disables WDR
function temporary. It should be considered when installer adjusts the
video with installation monitor via CVBS video signal.
D-WDR – Improves the visibility by compensating the video gain for
the dark area. Noise can increase in the dark area accordingly.
BLC – Improves the visibility for the dark object by the bright back
light. Outside area of BLC window can over saturate. BLC has a target
window for compensation and its size and position can be set by H-POS,
V-POS, H-SIZE and V-SIZE.
HLC – Cuts out the highlight area with black mask and excludes it from
compensation. Lower HLC LEVEL cut out video from the lower level.
Sets 3DNR level. LOW, MID, HIGH