Setup; Setup Location Requirements; Legs/Feet - CASO DESIGN Dry-Aged Cooler 688 Mode D'emploi Original

Take any packaging materials that are no longer required to "Green Dot" recycling
collection points for disposal.
► If possible, keep the original packaging for the device for the duration of the guarantee
period of the device, in order that the device can be re-packaged properly in the event
of a guarantee claim.
14.5

Setup

14.5.1

Setup location requirements:

In order to ensure the safe and trouble-free operation of the device, the setup location
must fulfil the following prerequisites:
 Place your appliance on a floor that is strong enough to support the appliance when it
is fully loaded.
 Locate the appliance away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption.
 Ambient temperature below 10°C or above 32°C will hinder the performance of the
appliance.
 This unit is not designed for use in a garage or any other outside installation.
Do not set up the device in a hot, wet or extremely damp environment or near

flammable material.
 The device requires an adequate flow of air in order to operate correctly. Leave a
clearance of 15 cm around the appliance.
 Do not cover up any openings on the device and do not block these off.
 The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
 The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they
guarantee the prerequisites for the safe use of this device.
 For energy saving reasons please ensure that the door is closed when the appliance is
turned on.
14.5.2

Legs/feet

There are feet (3 bigger feet and 1 small foot).
To level your appliance, adjust the front legs at the bottom of the appliance.
Please note
33