Moving The Appliance; Troubleshooting - CASO DESIGN Dry-Aged Cooler 688 Mode D'emploi Original

 Cabinet
The cabinet should be cleaned with a mild detergent and warm water.
Use a soft, damp cloth for drying.
 Vent opening
Dust or anything else may block the vent and hinder the cooling efficiency of the
appliance. Vacuum the vent if necessary.
 Container for condensed water (K)
Remove regularly the condensed water
with a sponge from the container for
condensed water.
The container is located on the back side
of the device at the right bottom.
Manual defrosting

Please defrost the device at least every 6 months. When you open the door of the device
frequently, you need to perform the defrosting more often. Turn off the power but do not
unplug the power plug. Let the appliance then defrost manually. Pay attention to the
container for condensed water(K) and remove the condensed water during the defrosting.
 Water tank
Clean the water tank with lukewarm water and a mild
cleaning agent as well as a soft cloth.
 Filter of Water tank
Clean the permanent filter of wattertank each 6 months.
Therefore remove the filter and clean it under running
lukewarm water. Replace the filter into the water tank
after this.
Metal shelves, metal suspension system and meat hooks

Remove the metal shelves, the metal suspension system and the meat hooks from the
equipment and clean them with methylated spirits for hygiene purposes.
18.3

Moving the appliance

Turn off the appliance first and then unplug the unit from the wall outlet. Remove all
content. Shurely tape down all lose items inside your appliance. Tape doors shut. Be sure
the Dry-Aged Cooler stays in the upright position during transportation.

19 Troubleshooting

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
40