Broan Elite EBS1244SS Notice D'utilisation page 15

30"
E
G
E
5
4
Fig.6
3. 30" HOODS ONLY – INSTALLATION OF THE HOOD ON THE LOWER PART OF THE
WALL CABINET USING PROVIDED METAL BRACKETS.
This model includes side installation to the wall cabinet by using 2 brackets B (Fig. 6 besides
steps 3-4, indicated in Fig 4).
1- Position template B on the wall cabinet, bearing in mind the measurements indicated
in Fig. 1-2 and the minimum distance from the cooktop.
- Mark the references to fix brackets A to the wall cabinet, as indicated in Fig. 6.
2 - Position the second template E on the side of the wall cabinet and make sure that the
line matches up with that traced in Fig. 6 - step 1.
3 - Mark and drill the 4 fixing holes (Fig. 6 - step 2).
- Fasten the 2 brackets G to the wall cabinet using the 4 screws D (Fig. 6 - step 3).
- Fasten the hood to bracket G using the 4 screws E (Fig. 6 - step 4-5).
4- Remove pin Y from bracket A. (Pin can be discarded.) Then place the insert X on the slot
of the bracket A, as indicated in Fig. 4 - step 3.
- Match the C screws with the L washer and fix the A bracket to the cabinet as indicated
in Fig. 4 - step 3.1. Pay attention not to completely tighten screws C before the bracket
firmly reaches the wall cabinet (Fig. 4 - step 3.2). After any adjusting, tighten the bracket
to the body (Fig. 4 - step 3.3).
- Fasten screw D to the wall cabinet as indicated in Fig. 4 - step 4.
- 15 -