Broan Elite EBS1244SS Notice D'utilisation page 10

1
B
2
Min 0-1/2"
Fig.4
1. INSTALLING THE HOOD ON THE BOTTOM SHELF OF THE WALL CABINET :
1. Remove pin Y from bracket A. (Pin Y can be discarded.) Then place the insert X on the
slot of the bracket A, as indicated in Fig. 4 - step 3.
Match the C screws with the L washer and attach the A bracket to the cabinet as indicated
in Fig. 4 - step 3.1. Do not completely tighten screws C to allow the bracket to slide back
and forth.
2. Position template B on the wall cabinet, bearing in mind the measurements indicated
in Fig.s 1 and 2 and the minimum distance from the cooktop.
- Mark the references to fasten brackets A to the wall cabinet, as indicated in Fig. 4.
3. Make sure the thickness of the wall cabinet is within the parameters indicated in Fig.
4 - step 2.
4. Insert the hood into the wall cabinet, ensuring the 2 side springs F are connected
correctly, as the weight of the unit will rest on these springs. Fasten the hood to the wall
cabinet using the screwdriver and the relative screws M and tighten until the hood is
24" - 36" - 30"
F
A
3
2
F
- 10 -
4
2
1
M