Broan Elite EBS1244SS Notice D'utilisation page 11

firmly against the wall cabinet (Fig. 4 - step 2).
5. Remove pin Y from bracket A. (Pin Y can be discarded.) Then place the insert X on the
slot of the bracket A, as indicated in Fig. 4 - step 3.
6. After any adjusting to ensure the bracket touches the wall cabinet, tighten the bracket
to the body (Fig. 4 - step 3.3).
- Fasten screw D to the wall cabinet as indicated in Fig. 4 - step 4.
- Once you have fastened the hood to the wall cabinet, adjust the spacer L, with the
screws P, to make the device line up with the rear wall cabinet (Fig.. 4 - step 5).
IMPORTANT - The range hood must be secured to wall studs or use drywall
anchors capable of supporting 75 lbs.
3
Y
L
4
D
D
X
L
C
A
3.1
3.2
3.3
C
D
Y
X
P
L
5
P
- 11 -
3.2
3.3