Broan Elite EBS1244SS Notice D'utilisation page 12

2. INSTALLATION OF THE HOOD INTO A WALL CABINET USING A HORIZONTAL DIVIDER
FOR SUPPORT.
Follow the steps below:
1 - Check the measurements indicated in Fig.s 1 and 2 and the minimum distance from
the cooktop, before installing the hood on the support shelf.
2 - Install a support shelf a the width of the cabinet interior at (9" from the bottom) (1/2"
thick).
3 - Make sure the thickness of the wall cabinet is within the parameters indicated in Fig.
4 - step 2.
4 - Install the hood in the wall cabinet and make sure the 2 side springs F are connected
correctly. Fasten the hood to the wall cabinet using the screwdriver and the relative screws
M and tighten until the device is firmly against the wall cabinet (Fig. 4 - step 2).
5 - Fasten the hood to the upper support shelf as indicated in Fig. 5 - step 6. - Once you
have fastened the hood to the wall cabinet, adjust the spacer L, with screws P, to fill the
gap between the hood and rear wall. (Fig. 4 - step 5).
IMPORTANT - The range hood must be secured to wall studs or using drywall
anchors capable of supporting 75 lbs.
- 12 -