Speck pumpen BADU Eco Touch-pro Fiche Technique page 18

Setting the priming parameters
The motor has to be stopped ("0" button) to
programme the priming time. Then press the
"SET" button again for at least 3 seconds until
the speed displayed in the display begins to
flash. Now the speed can be set with which the
motor is to start up during the priming time.
The speed can be changed with the buttons
"▼▲" and saved with "OK". After the priming
speed has been set, the length of the priming
time can be specified. The priming time can be
set between 0 (= Off) and 10 minutes.
Resetting
The motor can be reset to the state of delivery
by pressing the "SET" button for at least
15 seconds. The motor stops and the three
LEDs of the fixed speeds light up.
18 EN VG 766.2150.069 04/2014