Speck pumpen BADU Eco Touch-pro Fiche Technique page 17

Note: When the BADU Eco Touch-pro is used with an external control, the
connection to the external control has to be interrupted or the external
control has to be disconnected from the mains voltage when programming
the speed and the priming time!
Note: During the suction phase it is not possible to change the motor
speed. Through pressing and releasing of two speed buttons "1", "2" and/or
"3" – the suction time can be interrupted.
04/2014 VG 766.2150.069
Operation:
Press button "1", "2" or "3" to select the
preset fixed speed.
If the pump starts from a standstill, it starts up
in priming mode and subsequently with the
selected fixed speed.
As long as the pump is in the priming phase,
the LED of the selected speed flashes.
During running operation the pump is started
up to the fixed speed directly, without priming
time.
The motor is stopped by pressing the button
"0". The "Power" LED flashes and the display
shows "OFF".
Setting the fixed speeds
Press the button of the fixed speed which is to
be changed and then keep the "SET" button
pressed for at least 3 seconds until the speed
displayed in the display begins to flash. Now
the speed can be changed with the buttons
"▼▲". To save the speed confirm with "OK".
To cancel and retain the original speed press
the "SET" button.
EN 17