EMKO ESM-3711HN Mode D'emploi page 11

Temperature Alarm Delay After Power On Parameter
MODBUS ADDRESS:40017
When power is first applied to the device, this time delay must be expired for activation of
temperature alarm. It can be adjusted from 0 to 99 minutes.
Buzer Fonksiyon Seçimi Parametresi
Buzzer is active during this time
If buzzer function selection parameter value
observed. Buzzer stays active during this time. It can be adjusted from 1 to 99 minutes
When this parameter is 1, if decrement button is pressed,
condition buzzer is active till buzzer silence button is pressed.
Button Protection Parameter
Communication Mode Selection Parameter
Slave ID Parameter
Device communication address parameter (1 to 247).
Programming Section Accessing Password
It is used for accessing to the programming section. It can be adjusted from 0 to 9999. If it is
selected 0, password will not be asked
6.3 Modbus Adresses of Device Status Parameters (Read Input Register)
MODBUS ADDRESS:30001
MODBUS ADDRESS:30002
A
MODBUS ADDRESS:30003
MODBUS ADDRESS:30004
MODBUS ADDRESS:30005
Buzzer is inactive.
Buzzer is active at the end of the cooking time.
Buzzer is active if an alarm occurs.
Buzzer is active during sensor failures.
Buzzer is active at the end of the cooking time, alarm or sensor failures.
( Default =
( Default = 0 ) MODBUS ADDRESS: 400
There is no protection
Cooking time(Timer) can not be changed. Cooking ON/OFF operation is not
performed.
SET value can not be changed.
Cooking time (Timer) and set value can not be changed. Cooking ON/OFF
operation is not performed.
Cooking time (Timer) and set value can not be changed. Cooking ON/OFF
operation is performed when
PROKEY communication selected.
RS-485 communication selected.
( Default = 1 ) MODBUS ADDRESS=400
Temperature Value
Led Status : 0.bit C Led,6.bit OutputLed, 7.bit Alarm Led,
13.bit Program Led, 14.bit Set Led
Device Status : 0.bit Alarm Status
1.bit Buzzer Status
Output Status 0.Bit Output
Device Type and Device Version
( Default = 0 )
( Default = 1 ) MODBUS ADDRESS:40018
) MODBUS ADDRESS:40019
=0, this parameter can not be
button is pressed.
( Default = 0 ) MODBUS ADDRESS: 400
22
( Default = 0 ) MODBUS ADDRESS: 400
.
o
2.bit Sensor Break Status
is observed. In this
20
21
23
11