DSC WT5500 Instructions D'installation page 7

Programming Labels
1. Use this section to assign a meaningful name (e.g., Front Door, Hallway, etc.) to each zone.
,][8][Installer Code][,].
[
2. Enter Keypad Programming by pressing
3. Enter the 3-digit section number for the label to be programmed.
4. Use the arrow keys (<>) to move the cursor underneath the letter to be changed.
5. Press number key 1 through 9, corresponding to the letter you require. For example, pressing number key 2
once will display the letter D; pressing it again will display the letter E; pressing it a third time will display the
letter F, and so on.
[1] - A, B, C, 1 [4] - J, K, L, 4 [7] - S, T, U, 7 [0] - Space
[2] - D, E, F, 2 [5] - M, N, O, 5 [8] - V, W, X, 8
[3] - G, H, I, 3 [6] - P, Q, R, 6 [9] - Y, Z, 9,0
6. When the required letter or number is displayed use the arrow keys (<>) to scroll to the next letter.
7. When you are finished programming the Zone Label, press [
8. Repeat Steps 3 through 7 until all Labels are programmed.
ASCII Characters
, ,
]. Scroll to 'Save' and press [ ] again.
Label Library
The Label Library is a database of words commonly used when programming labels. Individual words can be combined as
needed. e.g., Front + Door. Each line of the display supports a maximum of 14 characters. If a word will not fit on a line,
scroll right until the cursor appears at the first character of the second line then add the word.
To program a custom label using the Label Library:
1. Enter keypad programming and select the label to change. e.g., [*][8][Installer Code][*][001] (to program the label
for zone 01).
2. Press [*] to open the "Select Options" menu.
3. Press [*] again to select the "Words" option.
4. Enter the 3-digit number corresponding to a word (see Words table below) or use the scroll keys [<][>] to
view words in the library.
5. Press [*] to select the word.
6. To add another word, repeat the above procedure from step 2.
7. To add a space, press the right scroll key [>].
8. To clear characters, select "Clear to End" or "Clear Display" from the "Select Options" menu.
9. To save the current label, press [*] to access the "Select Options" menu, scroll left [<] to "Save" then press
[*] again.
Broadcasting LCD Labels
LCD programming is done using Keypad 1 or, if using the SCW9055/SCW9057, from the main control panel. Labels are
broadcast to all other WT5500 keypads enrolled on the system.
Perform the following in order to broadcast labels:
1. Program Keypad 1 or the SCW9055/9057 control panel completely.
,
2. Enter keypad programming by pressing [
,
3. Enter Section [998] and press [ ]. The label information is then broadcast.
NOTE: This operation may take several minutes.
4. When the label broadcast is complete press the [#] key to exit.
NOTE: Label broadcast from Keypad 1 is only compatible with other WT5500 keypads (PC9155 only).
,
][8][Installer Code][ ] at the keypad that was programmed.