Publicité
Les langues disponibles
Les langues disponibles
3
INFORMATION YOU NEED TO KNOW
Clearances and Dimensions
• Dimensions that are shown in Figure 1 must
be used. Given dimensions provide minimum
clearance. Locate electrical outlet in the shad-
ed area in the upper left-hand corner of the cut-
out. See Figure 4.
• Contact surface must be solid and level. Pay
special attention to the floor on which the appli-
ance will sit. The floor of the opening should be
constructed of plywood strong enough to sup-
port the weight of the oven (about 100 pounds).
• Check location where the Drawer Microwave
will be installed for proper electrical supply.
• Your appliance can be built into a cabinet or
wall by itself or under a gas or electric wall
oven.
• Be sure that the clearance of the floor between
the wall oven and the Drawer Microwave is a
minimum of 2".
• The microwave interior will easily accommo-
date a 9" x 13" oblong dish or a bag of micro-
wave popcorn.
Drawer Microwave Oven / Installation Manual
GROUNDING
INSTRUCTIONS
This appliance must be grounded. In the event of
an electrical short circuit, grounding reduces the
risk of electric shock by providing an escape wire
for the electric current. The Drawer Microwave is
equipped with a cord having a grounding wire with
a grounding plug. The plug must be plugged into
an outlet that is properly installed and grounded in
accordance with the National Electrical Code and
local codes and ordinances.
WARNING: Improper use of the grounding plug
can result in a risk of electric shock. Do not use
an extension cord. If the power supply cord
is too short, have a qualified electrician or
serviceman install an outlet near the appliance.
3-Prong plug
Grounding pin
3-Prong receptacle
Grounded receptacle box
5 / 19 EN
Publicité
Chapitres
