Publicité
Les langues disponibles
Les langues disponibles
4
INSTALLATION INSTRUCTIONS
Standard Mount Drawer
Installation
1. Place the drawer adjacent to the wall or cabinet
opening. Plug the power supply cord into the
electrical outlet.
2. Carefully guide the drawer into the prepared
opening. Avoid pinching the cord between the
oven and the wall.
3. Slide the drawer all the way until the mounting
flange is flush with the face of the cabinet. See
Figure11A.
4. Open the drawer. Using the 4 holes on the
drawer as a template, pre-drill the cabinet using
a
⁄
" bit. See Figure 11A.
1
16
5. Secure the drawer with the 4 screws supplied.
See Figure 11B.
A
B
Parts Supplied - 4 Screws
Figure 11
Flush Mount Drawer
Installation
1. Prepare cabinet opening as shown in Figures
5, 6, 7.
2. Install deflector as shown in Figure 8A.
3. Place the drawer adjacent to the wall or cabinet
opening. Plug the power supply cord into the
electrical outlet.
10 / 19 EN
4. Carefully guide the drawer into the prepared
5. Slide the drawer all the way back until the
6. Open the drawer. Using the 4 holes on the
7. Secure the drawer with the 4 screws supplied.
Model and Serial Number
Location
The nameplate includes model number and
serial number. Open the Drawer Microwave fully.
The label is slightly beyond the back wall of the
microwave cavity facing up from the flat surface.
Care, Cleaning and
Maintenance
Refer to the Use and Care Manual for cleaning
instructions.
Before You Call for Service
Mounting Screws
Read the BEFORE YOU CALL FOR SERVICE and
operating instruction sections in your User Manual.
It may save you time and expense. The list includes
common occurrences that are not the result of
defective workmanship or materials in this range.
Refer to the warrant for toll-free service number
and address. Please call or write if you have
inquiries about your microwave product and/or
need to order parts.
Drawer Microwave Oven / Installation Manual
opening. Avoid contact with the sides of the
cutout opening and also pinching the cord
between the oven and the wall.
mounting flanges touch the cleats mounted in
the cabinet opening.
drawer as a template, pre drill the cabinet using
a
⁄
" bit. See Figure 11A.
1
16
See Figure 11B.
Publicité
Chapitres
