Mounting Oven To The Wall; Preparation Of Top Cabinet - Beko MWOTR30102SS Mode D'emploi

9

MOUNTING OVEN TO THE WALL

IMPORTANT: Do not grip or use handle during
installation.

Preparation of top cabinet

You need to drill holes for the top support screws
and a hole large enough for the power cord to fit
through.
• Read the instructions on the top cabinet tem-
plate
• Tape it underneath the top cabinet
• Drill the holes, following the instructions on the
template.
NOTE: the top cabinet template must be taped to
the underside of the top cabinet before proceed-
ing with installation.
Step 1
• Protect the top of your range by placing a por-
tion of the carton or some other heavy material
over the cooking surface before mounting your
oven.
Step 2
• Lift the microwave oven and tilt it forward. Hang
the unit on two tabs at the bottom of the mount-
ing plate. See Figure 22.
Figure 22
Over The Range Microwave Oven / Installation Manual
TINSKB303MRR0_MWOTR30102SS_Beko OTR_Install Manual.indd 13 TINSKB303MRR0_MWOTR30102SS_Beko OTR_Install Manual.indd 13
Step 3
• Thread power cord through the hole at the
bottom of the top cabinet. Swing the unit
upward to meet the top of the mounting plate
and hold it securely. See Figure 23.
Figure 23
Step 4
• Then insert a bolt down through each hole in
the upper cabinet bottom. Tighten the bolts
until the gap between the upper cabinet and
microwave oven is closed. See Figure 24.
Figure 24
13 / 29 EN
8/19/20 2:41 PM 8/19/20 2:41 PM