Changing Colour Strips Of The Sensor Unit - hager WXH20 Serie Mode D'emploi

Setting mode 3: Calibrating cooker type
Setting mode 3 is called up. The status LED (5)
flashes yellow-green.
Two selection options are available for calibrat-
ing the cooker type.
Option 1: Cooker and oven are jointly connect-
ed to the power control unit (Figure 10, left).
Switch on oven.
„
Press operation button (1).
„
The sensor unit confirms the identification
of the cooker type with acoustic and optical
signals.
Switch off oven.
„
Manual calibration in option 1 is completed.
Option 2: Hob is connected individually to the
power control unit (Figure 10, right).
Switch on the most powerful hotplate to the
„
highest level.
Press operation button (2).
„
The sensor unit confirms the identification
of the cooker type with acoustic and optical
signals.
Switch off hotplate.
„
Manual calibration in option 2 is completed.
The cookguard ends the automatic setting
mode.

5.4 Changing colour strips of the sensor unit

The sensor unit can be adapted to match
the colour of the wall using the colour strips
supplied.
Remove sensor unit carefully from the
„
mounting bracket (8).
Remove front cover (6) by lifting at the back
„
of the sensor unit.
Attach the desired colour strips to the sensor
„
unit.
With an induction cooker a suitable pot must be
used for commissioning.
Setting mode 4: Setting and testing
potential-free contacts
Additional information about the two poten-
tial-free outputs AUX1 and AUX2 can be
found in chapter 4.5.
Setting mode 4 is called up. The status-LED (5)
flashes white (normal setting) or red (inverted
setting).
Press operation button 1 (1) for five sec-
„
onds.
Changing between the two operation modes
of the AUX outputs:
Normal AUX mode: The status LED (5)
flashes white.
Inverted AUX mode: The status LED (5)
flashes red.
Testing AUX outputs:
Short press on operation button (1).
„
AUX1 changes bewtween ON and OFF
Short press on operation button (2).
„
AUX2 changes bewtween ON and OFF
To terminate the setting mode 4.
Press operation button (3).
„
The setting mode is completed.
When attaching the colour strips to the
sensor unit, make sure that no sensor is
covered.
Fasten transparent front cover to the sensor
„
unit.
Press sensor unit onto the mounting bracket
„
(8).
z
35