Automatic Child Lock; Dangerous Situations; Alarm Confirmation By Tapping The Sensor Unit (Optional) - hager WXH20 Serie Mode D'emploi

4.2 Automatic child lock

The automatic child lock is deactivated by
default.
Switching on child lock
Keep the operation button (1) pressed for 5
„
seconds.
Two high acoustic signals (●●) sound and the
status LED flashes green twice. Child lock is
switched on.
The automatic child protection is activated
about
10 ... 60 minutes after finishing cooking, in order
to prevent the cooker/hob from being switched
on accidentally.

4.3 Dangerous situations

If a potential hazard is determined, a pre-alarm
is triggered if necessary. If this is not acknowl-
edged by the user, the power control unit
switches off the power supply to the cooker/hob
after 15 seconds. If the critical situation on the
cooker has been remedied, the pre-alarm can
be cancelled or the power supply to the cooker
can be reactivated by pressing the operation
button (3) or by tapping on the sensor unit (see
4.4) of the pre-alarm.
Pre-alarm has tripped
Closely examine the situation on the cooker.
„
Press the operation button (3) if the situation
on the cooker is OK.
Pre-alarm has been acknowledged. The
cooker is not switched-off.

4.4 Alarm confirmation by tapping the sensor unit (optional)

The operation button (3) is pressed as standard
to cancel the pre-alarm or to reconnect the
power supply to the cooker. Alternatively, this
can also be achieved simply by tapping the
sensor unit.
Activating/deactivating the tap
function:
Hold the operation buttons 1 and 3 for ap-
„
prox. 5 seconds simultaneously until a signal
tone sounds.
Switching off child lock
Keep the operation button (1) pressed for 5
„
seconds.
A low acoustic signal (●) sounds and the
status LED flashes red. Child protection is
switched off.
Switching on cooker with activated
child lock
Press operation button (3).
„
Switch on cooker/hob.
„
If the operation button (3) is not pressed
first, the automatic child lock switches off the
power supply of the cooker after 5 seconds.
Switching off the cooker
If the pre-alarm is not acknowledged within
15 seconds, the power supply of the cooker is
interrupted.
If there is no danger or if the danger has been
remedied, the power supply can be restored by
pressing the operation button (3).
Avoid dangerous situations in the further
course of cooking.
In the case of too frequent false alarms,
manual commissioning must be carried out.
The Status LED (5) of the sensor unit flash-
es yellow 3x and then red 3x.
The tap function is activated.
OR:
The Status LED (5) of the sensor unit flash-
es yellow 3x and then blue 3x
The tap function is deactivated.
z
25