Manual Commissioning/Device Setting - hager WXH20 Serie Mode D'emploi

5.3 Manual commissioning/Device setting

Setting mode Setting
Mode 1 Setting alarm limit
Mode 2 Establishing radio connection
Mode 3 Calibrating cooker type
Mode 4 Set and test AUX connection
Manual commissioning is necessary if the
cooker was replaced, the cooker dimensions and
mounting height of the sensor unit vary from the
standard values (Figure 8) or if false alarms occur
too frequently.
Manual commissioning is performed via four
setting modes on the sensor unit:
The setting modes can be changed successive-
ly or individually.
WARNING!
ç
Risk of accident!
If the setting of the alarm limit is too high, the detection of hazards is delayed.
Do not set alarm limit higher than 8 during the installation!
Colour of
status LED (5)
red
blue
*
recommended alarm limits
Tabele 5. Setting modes
Number of Alarm limit
acoustic
signals
●●● ●●●
●●● ●●
●●● ●
●●●
●●
●
●●● ●●●
(Standard)*
●●● ●●
●●● ●
●●●
●●
●
Table 6: Alarm limits
Colour of status LED (5)
lights up white
flashes purple-blue
flashes yellow-green
flashes white (normal AUX mode)
flashes red (reversed AUX mode)
Keep the operation button (2) pressed for
„
5 s.
Setting mode (1) is active. Status LED (5)
lights up white.
Press operation button (3) repeatedly until
„
next setting mode is reached.
The Status LED (5) signals the set mode in
the appropriate colour.
Installation
height: Wall
mounting
12
11
10
9
8
7*
6
50 ... 60 cm
5*
4*
3
2
1
Installation height:
Installation under the
extractor hood
45 ... 55 cm
55 ... 65 cm
65 ... 75 cm
75 ... 85 cm
z
33