Scanning The Picture Of The Alarm Recordings - Alarm Scan; Displaying The Alarm List - Alarm Recall - Sony SVT-L230P Mode D'emploi

Scanning the Picture of the
Alarm Recordings — Alarm Scan
1
1
Turn on the power of the equipment to be used.
2
Press SEARCH in stop mode.
The AL SCAN lights in the display window or on
the monitor screen.
H M S
In the display window
3
Press ) FF or 0 REW.
The portions where the alarm function worked are
subsequently played back for five seconds one by
one.
Press P PAUSE to view a certain scene in still mode.
(Alarm scan mode is released.)
Press p STOP, z PLAY, )
release alarm scan mode.
Notes
• If the tape reaches the end during scanning, the tape
is rewound and the unit enters the stop mode at the
beginning of the tape.
• You can use the alarm scan only when the tape is
recorded in 8-hour alarm recording mode and the
recorded section is longer than 20 seconds.
3 2
1 H 1 2 M 0 6 S
A L S C A N
On the monitor screen
FF, or 0 REW to
Displaying the Alarm List —
Alarm Recall
1
MENU RESET
1
Turn on the power of the equipment to be used.
2
Press MENU until the ALARM TIME display
appears on the screen.
The alarm count, date and time are displayed.
The date and time are displayed up to recent eight
times.
<ALARM TIME>
008 03-12 19:00
01-11 23:00
25-10 15:00
25-10 08:00
25-10 06:00
To turn off the alarm list on the screen
Press SEARCH. The normal display appears.
To reset the alarm data
Press MENU RESET while the ALARM TIME
display is on the screen.
The alarm count shows "000".
2
SEARCH
Time
Day-Month
Alarm count
31