Programming; Default Settings; Storing One-Touch Numbers - Bpt integra IMT/200 Mode D'emploi

Default settings

• Call volume: 3 (highest level).
• Call note: melody 1.
• Hands-free volume: 3 (highest level).
• Dialling mode: DTMF.
• Pause length: 1 s.
• R key (flash): 100ms.
• Video function keys: enabled with bpt
telephone interface.
The programming mode can be entered
either with the receiver lifted or in hands-free
mode.
You can tell you have entered programming
mode as the red LED comes on and there is
no dial tone.
Ot is not necessary to exit and reenter the
programming mode when programming a
number of functions.
During programming, pressing any of the
keys produces a short beep, the storing of
the data produces a longer sound, and
errors an extended beep.
WARNING. If the programming is carried
out with the unit connected to the local line,
after approx. one minute, the dissuasive
action of the telephone exchange may inter-
fere with ptogramming. In this case, hang up
the receiver and resume programming from
where you left off.

PROGRAMMING

Storing one-touch numbers

0...9
0
ABC
1
GHI
4
PQRS TUV
7
0...9
Repeat the operation to store the next num-
ber. Up to 10 different numbers can be sto-
red.
( 1 ) If the video entry handset is connected to
a switchboard, a pause must be inserted
between the 0 (number dialled to get an
outside line) and the telephone number.
To insert a pause, press the RP key e.g. 0
RP 0123 456789.
The length of the pause can be doubled by
pressing the RP key twice.
23
Lift the receiver
or
press the hands-free key.
Press the PROGRAMMING
key.
Press
DIAL key.
Press the key the telephone
WXYZ
÷
9
number is to be associated
with (in the range 0 to 9).
DEF
2 3
Key in the desired number
JKL MNO
5 6
(max. 20 digits) (
WXYZ
8
9
0
Press
DIAL key to save.
Press the PROGRAMMING
key.
Replace the receiver
or
press the hands-free key.
ONE-TOUCH
the
1 ).
ONE-TOUCH
the