Timer Function - Fulgor Milano CH 302 ID TC Manuel D'utilisation

Timer function

The Timer function can be used as a timer for the
cooking point or as an independent alarm clock. The
two rear 7-segment displays (6) are also used for
displaying the remaining time in minutes, until the
timer alarm goes off.
Timer selection
The simultaneous activation of the "+" and "-" is used for selecting the
timer function. There are two different timer modes:
- Timer for the cooking point (the timer is assigned to a cooking point).
When the set time runs out, there is an audible and visual signal and
the relative cooking point turns off.
- Independent alarm (the timer works without reference to a cooking point)
- If an independent alarm timer is set, only the display (6) will turn on, but if
you have programmed a timer associated with a cooking are, the LED
"8A" or "8B" will be on.
When the set time runs out, there is an audible and visual signal in this
mode as well, but the cooking points are not turned off.
Selecting a timer
a timer is selected by simultaneously pressing the plus and minus keys
with the control activated. If you have previously selected a cooking point,
the timer of that cooking point will light up. Plus, this will be indicated by
the flashing decimal point on the display (LED timer 8A-8B) of the cooking
point. If no cooking point had been previously selected, the cooking alarm
timer will be activated. In this case, all the decimal points will be off (
8A - 8B).
If different timers are active, you can select the desired timer by pressing
the plus and minus keys several times. The timers of the active cooking
points will be turned off in clockwise order. After the last cooking point
timer, the cooking alarm timer will be selected and after that the first
cooking point timer will be selected again. The selection time is 10
seconds. This time is set from scratch at each change of the value of the
timer by pressing the plus or minus key. When this time runs out, the timer
with the shortest time set will be displayed. You can end the selection
early by selecting a cooking point.
Setting the timer value
when a timer has been selected, you can change the timer value using
the plus or minus keys.
If a timer value has not been set, pressing the minus key will set a value
of 30 minutes, which can then be changed.
By holding down the plus or minus key longer, the set value will
change faster. At a setting value of 99 or 01, the automatic repeat will
automatically stop. If the timer of a cooking point is set, this will be
indicated on the related timer LED (8A-8B) of the cooking point, even at
the end of selection, by a static or flashing decimal point (static if the timer
is set but not displayed because there are other timers with less time)
(flashing if the timer is set and is displayed because it is the timer with the
shortest time). In the case of setting a generic cooking timer.
Turning off the timer early
You can turn off the timer by setting the timer value to 00. In the case of a
cooking point timer, the corresponding cooking point will stay on.
Counting down the time set on the timer: the time countdown starts as
soon as a timer is set. If the value is changed using the plus or minus
keys, the timer starts on a full minute and any seconds that may have
elapsed are cancelled.
Signal of a timer whose set time has run out
If the timer value has reached 00, this will be indicated by an audible
and visual signal. If a cooking point timer has reached the set value, the
corresponding cooking point will be turned off. Any cooking points or
timers selected will be deselected.
The timer value (00) is automatically displayed again and flashes. If it is a
cooking point timer, the corresponding decimal point will also flash. The
signal lasts for 2 minutes, unless it is stopped earlier by pressing any key.
After the signal, all the active cooking point displays will be visible again.
15
GB