Leuze BPS 8 S M 100 Serie Mode D'emploi page 24

EN
Commissioning
3
All dimensions in mm
A Turning connector, 90°
B Indicator diodes:
B1: Status LED
B2: Decode LED
C Scanning beam
Divergence max. 5 mm at 150 mm
reading distance
D Optical axis
E Bar code tape
Mounting
Installation via holes for M 4-sized screws in the case or via a mounting device
BT 8-01 (accessory).
Ä
Observe the installation dimensions and system arrangement!
NOTICE
The mounting instructions can be found in the operating instructions.
CAUTION
Strain relief!
Ä
Install strain relief at a distance of max. 15 c m to the connectors.
NOTICE
Degree of protection IP 67!
Degree of protection IP 67 is achieved only if the connectors and caps
are screwed into place.
24
F Reference plane
G Pitch of the scanning beam:
α = 10° for a bar code tape height
of 47 mm
α = 5° for a bar code tape height of
25/30 mm
H Reading distance
J Reading field width
X Height