Leuze BPS 8 S M 100 Serie Mode D'emploi page 22

EN
Laser safety notices
ATTENTION
LASER RADIATION – CLASS 2 LASER PRODUCT
Do not stare into beam!
The device satisfies the requirements of IEC/EN 60825-1:2014 safety
regulations for a product of laser class 2 and complies with 21 CFR
1040.10 except for conformance with IEC 60825-1 Ed. 3., as described
in Laser Notice No. 56, dated May 8, 2019.
Ä
Never look directly into the laser beam or in the direction of re-
flected laser beams!
If you look into the beam path over a longer time period, there is a
risk of injury to the retina.
Ä
Do not point the laser beam of the device at persons!
Ä
Interrupt the laser beam using a non-transparent, non-reflective
object if the laser beam is accidentally directed towards a person.
Ä
When mounting and aligning the device, avoid reflections of the
laser beam off reflective surfaces!
Ä
CAUTION! Use of controls or adjustments or performance of pro-
cedures other than specified herein may result in hazardous light
exposure.
Ä
Observe the applicable statutory and local laser protection regula-
tions.
Ä
The device must not be tampered with and must not be changed in
any way.
There are no user-serviceable parts inside the device.
Repairs must only be performed by Leuze electronic GmbH + Co. KG.
Ä
If the scanner motor fails during the emission of laser radiation,
the limit value of laser class 2 in accordance with IEC/
EN 60825‑1:2014 could be exceeded. The device has safeguards
to prevent this occurrence.
Ä
If the emitted laser beam is at a standstill, immediately disconnect
the faulty bar code positioning system from the voltage supply.
Ä
The BPS 8 emits scanned optical radiation at a wavelength of
655 nm (red).
Ä
Looking at the device's mirror and operating at the lowest scan-
ning rate (500 scans/s) at a viewing distance of 100 mm results in
pulses with a pulse duration of 420 µs on the retina of the eye.
The total pulse peak power at the exit window is less than
1.7 mW.
Ä
The average laser power is less than 1 mW in accordance with
laser class 2 acc. to IEC/EN 60825-1:2014.
22