Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Square frame to rim of bath/whirlpool.
Secure sides of apron frame to studs with screws
provided. Shim if necessary to fill any gap.
Secure bottom of apron frame to subfloor with screws or
floor anchors. Shim if necessary to fill any gap.
Thread the carriage bolt out until it makes contact with the
bath. Then secure by tightening the two wingnuts.
Install apron panel by centering on apron frame. Insert
upper edge under bath rim. Press panel onto frame so
each of the fasteners located on the backside are
engaged.
Install wall covering and flooring. Maximum wall thickness
is 1-1/2" (3.8cm). Maximum floor thickness is 2" (5cm).
REMOVE THE APRON
When servicing the unit, pry bottom of panel gently using
a flat-blade screwdriver.
Kohler Co., Kohler, WI U.S.A.
Square
Apron Frame
Subfloor
Fastener
Apron
Panel
Screwdriver
3
Carriage Bolt
Bath
Shim (if necessary)
Screw
Apron
Frame
Apron Panel
Apron Frame
1011308-2-
Stud
B
Publicité
Table des Matières
