Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
INSTALL THE BATH/WHIRLPOOL
Install bath/whirlpool according to the instructions
included with the product.
Make sure 2x4 studs are located at front corners of bath.
These will be required when installing the apron.
INSTALL THE APRON
The apron ships assembled. Remove the apron panel
from the apron frame and set the panel aside before
beginning the installation.
Insert bottom of apron frame under rim of bath/whirlpool.
Center and push apron frame up until it contacts
underside of bath rim.
Thread one wingnut onto the carriage bolt and add one flat
washer (See Detail). Insert this assembly from the rear of
the apron frame into the hole in the upper center of the
apron frame. Add the second flat washer and wingnut,
leaving them loose at this time.
B
1011308-2-
2x4 Stud
Apron
Panel
Apron Frame
Push
frame
up
Wingnut
Flat
Washer
Apron
Frame
2
2x4 Stud
Apron
Frame
Bath Rim
Subfloor
Bath
Carriage
Bolt
Kohler Co., Kohler, WI U.S.A.
Publicité
Table des Matières
