Before You Begin - Kohler SOK K-1188 Guide D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Thank You For Choosing Kohler Company
We appreciate your commitment to Kohler quality. Please take a few minutes to review this manual before
you start installation. If you encounter any installation or performance problems, please don't hesitate to
contact us. Our phone numbers and website are listed on the back cover. Thanks again for choosing Kohler
Company.
Recommended Tools and Materials
Introduction
Please read these instructions carefully to familiarize yourself with the required tools, materials, and
installation sequences. Follow the sections that pertain to your particular installation. This will help you
avoid costly mistakes. In addition to proper installation, read all operating and safety instructions.
All information in this manual is based upon the latest product information available at the time of
publication. At Kohler, we constantly strive to improve the quality of our products; we therefore reserve the
right to make changes in product characteristics, packaging, or availability at any time without notice.

Before You Begin

Your overflowing bath is designed for drop-in island installation. Undermount and alcove installations are
also possible.
You must install the overflowing bath onto an adequately supported, level subfloor to permit adequate
leveling during installation.
Provide properly dimensioned framing.
Choose a fill spout which will provide adequate reach and a minimum 2" (5.1cm) air gap above the
bathing well rim of the overflowing bath. You may need to build up the deck material to obtain adequate
air space because the outer rim may be lower than the bathing well rim depending on the specific area of
the overflowing bath.
Follow local plumbing codes.
The overflowing bath must be filled with water through the bathing well, not the overflow channel.
If you plan to install a deck-mounted, hand-held shower, the diverter vacuum breaker must maintain a
minimum 1" (2.5cm) air gap above the outer rim.
When using the K-922 or K-923 Laminar Bath Spout with drip tray K-924, the distance from the finished
wall to the outside wall of overflow channel should not exceed 2" (5.1cm).
1005288-2-D
4
Kohler Co.

Publicité

Table des Matières
loading

Table des Matières