Connection To The Evaluation Unit - Balluff BTL7-S5 Serie Notice D'utilisation

BTL7-S5_ _(B) -M _ _ _ _ -P-S32/S115/S147/KA_ _/FA_ _
Transducer – Profile Style
8
Technical data (continued)
8.7

Connection to the evaluation unit

The maximum sampling frequency f
current value is available with each sampling, can be found
in the following graphic:
f in Hz
A,max
Fig. 8-1: Maximum sampling rate depending on the nominal length
(for position output) The maximum sampling rate for
velocity output is limited to 3.3 kHz.
The maximum SSI clock frequency f
the cable length :
1)
f in kHz
Clk,max
Fig. 8-2: Maximum SSI clock frequency depending on the cable length
20 english
, at which a new
A,max
is dependent on
CLK, max
The minimum sampling frequency f
Nominal length in mm
Cable length in m
1) For longer length: required cable cross-section ≥ 0.6 mm
is 62,5 Hz.
A,min
(1) 1 magnet
(2) 2 magnets
(only BTL7-S510(B)-...)
2 or ≤ AWG19