Fcc Statement - HoMedics NMS-630H Manuel D'instructions

LED INDICATOR
6
POWER BUTTON
To turn on the massage functions,
press the power button once. To turn
the massager off, press the power
button again.
SHIATSU REVERSE BUTTON
The massager will begin with an
inward rotating motion. To change
the direction of the massage nodes
simply press the shiatsu reverse
button and the nodes will begin
rotating in an outward motion.
Pressing the button again will
change the direction back to an
inward rotating direction.
MASSAGE SPEEDS BUTTON
Your massage will begin at high
speed. Press the intensity control
button once to activate the low speed
setting.
HEAT BUTTON
For soothing heat when massage is
on, simply press the heat button and
the massage nodes on the neck unit
will illuminate. To deselect, press the
button again and the corresponding
massage nodes will stop glowing.
CONVENIENT AND PORTABLE
The rechargeable battery makes this unit perfect for use at home or in the office.
Note: The actual product materials and fabrics may vary from the picture shown.
Note: There is a 15-minute auto shutoff on the unit for your safety.

FCC STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
NOTE: HoMedics is not responsible for any radio or TV interference caused by unauthorized modifications
to this equipment. Such modifications could void the user authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
7