Wall Attachment - oventrop Regumaq X-30-B Mode D'emploi

5.3 Wall attachment

1. After removal of the packaging material, take
off front insulation shell.
2. Lift product assembly out of rear insulation
shell.
3. Fix enclosed angled wall bracket (1) into rear
insulation shell (2) (arrow) from behind and
click into position.
4. Hold rear insulation shell to required installation
place and position.
5. Adjust perpendicular position of the rear insu-
lation shell with the help of the spirit level.
6. Mark drill holes for the angled wall bracket on
the wall.
7. Take rear insulation shell off the wall.
8. Drill holes for the angled wall bracket and
equip with dowels.
9. Remove angled wall bracket for the rear insu-
lation shell and mount onto the wall using
screws M 8 x 70 and the enclosed washers.
10. Suspend rear insulation shell in the angled
wall bracket and use a drilling jig for the fixing
screws of the product assembly.
11. Choose four drill holes (arrows Illustr. 9) for
fixing the product assembly and mark them
on the wall.
12. Take off rear insulation shell. Drill holes for the
fixing screws of the product assembly and
equip with dowels.
13. Suspend rear insulation shell in the angled
wall bracket.
14. Suspend product assembly (3) in the angled
wall bracket and mount onto the wall with the
help of screws M 8 x 100 and the enclosed
washers.
15. Install pipework according to the installation
scheme, see "Connection of the supply pipes"
(see 5.4).
26
Illustr. 9: Rear insulation shell, angled wall bracket
Illustr. 10: Rear insulation shell, angled wall bracket