Harbor Breeze MAYFIELD C-BTH44ABZC5L Mode D'emploi page 14

Ventilateur de plafond
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

FINAL INSTALLATION
10.
Attach applicable pull chain extensions (F) or
custom pull chain extensions (not included) to
the fan and light pull chains.
Assembly is now complete.
11.
If you do NOT wish to use the light kit,
remove the hex nut (P) and 11 mm lock washer
(K) from the threaded rod at the top of the light
kit fitter (D). Unscrew the switch housing cap to
remove it from the light kit fitter (D), and then
gently feed the BLACK and WHITE wires from
the light kit fitter (D) through the hole in the
middle of the switch housing cap.
WARNING: RISK OF SHOCK. The molex
safety caps should not be removed unless a
light kit will be immediately installed and the
power should be turned off prior to molex safety
cap removal and light kit installation.
Place cap (DD) firmly in hole in middle of
12.
switch housing cap. Align holes in switch
housing cap with holes in switch housing of
motor assembly (C). (Make sure to align gap
on top edge of the switch housing cap with the
reverse switch on switch housing for the
correct fit.) Secure switch housing cap with
three switch housing cap screws (L) previously
removed (Step 5, page 12). Tighten all three
switch housing cap screws (L) securely.
Hardware Used
DD
Cap
10
(For Fan)
(For Light)
11
12
C
L
x 1
14
F
WHITE BLACK
O
P
K
Switch
Housing
Cap
D
Switch Housing
Switch
Housing Cap
DD
L

Publicité

Chapitres

Table des Matières
loading

Table des Matières