Klein Tools CL320 Manuel D'instructions page 12

ENGLISH
CONTINUITY
1. Insert RED test lead into VΩµA jack
into COM jack
Continuity/Resistance/Capacitance/Diode-Test
NOTE: The meter defaults to Continuity testing in this mode. Ensure
that the Continuity Testing icon
press the "SELECT" button
2. Remove power from circuit.
3. Test for continuity by connecting conductor or circuit with test
leads. If resistance is measured less than 10Ω, an audible signal
will sound and display will show a resistance value indicating
continuity. If circuit is open display will show "OL".
Black lead
DO NOT attempt to measure continuity on a live circuit.
µA DC CURENT (LESS THAN 200 µA)
1. Insert RED test lead into VΩµA jack
COM jack
4
µA setting.
2. Remove power from circuit and open circuit at measurement point.
3. Connect test leads in series with the circuit.
4. Apply power to the circuit to take the measurement.
Black lead
DO NOT attempt to measure more than 200 µA.
12
OPERATING INSTRUCTIONS
, and rotate function selector switch
4
12
Red lead
, and rotate function selector switch
Red lead
, and BLACK test lead
5
is visible on the display. If not,
repeatedly until the
, and BLACK test lead into
5
to the
2
setting.
icon is shown.
to the
2