Klein Tools CL320 Manuel D'instructions page 5

To ensure safe operation and service of the meter, follow these instructions.
Failure to observe these warnings can result in severe injury or death.
• Before each use verify meter operation by measuring a known voltage
or current.
• Never use the meter on a circuit with voltages that exceed the category
based rating of this meter.
• Do not use the meter during electrical storms or in wet weather.
• Do not use the meter or test leads if they appear to be damaged.
• Use only with CAT III or CAT IV rated test leads.
• Ensure meter leads are fully seated, and keep fingers away from the
metal probe contacts when making measurements.
• Use caution when working with voltages above 25V AC RMS or 60V DC.
Such voltages pose a shock hazard.
• To avoid false readings that can lead to electrical shock, replace batteries
when a low battery indicator appears.
• Do not attempt to measure resistance or continuity on a live circuit.
• Always adhere to local and national safety codes. Use personal protective
equipment to prevent shock and arc blast injury where hazardous live
conductors are exposed.
• To avoid risk of electric shock, disconnect leads from any voltage source
before removing battery door.
• To avoid risk of electric shock, do not operate meter while battery door is removed.
AC (Alternating Current)
DC (Direct Current)
Double Insulated Class II
Warning or Caution
Diode
Hz
Frequency
%
Duty-cycle
°F/°C
Temperature (Fahrenheit / Celsius)
COM Common
% Duty cycle
Backlight
Capacitance
Positive
AC AC (Alternating Current)
Negative Reading
Auto Ranging
MIN Minimum Value Hold
Low Battery
°F
Degrees (Fahrenheit)
M Mega (value x 10
m milli (value x 10
n nano (value x 10
A Amps
Hz% Frequency/Duty Cycle
NCV Non-Contact Voltage Tester
Hazardous Voltage Indicator
WARNINGS
SYMBOLS ON METER
SYMBOLS ON LCD
)
6
)
-3
)
-9
AC/DC Current
Resistance (in Ohms)
Audible Continuity
Ground
Risk of Electrical Shock
Capacitance
V Voltage (Volts)
A Amperage (Amps)
NCV Non-Contact Voltage Tester
SEL Select
Hz Frequency
Diode Test
Negative
DC DC (Direct Current)
Data Hold
MAX Maximum Value Hold
Auto Power Off
Audible Continuity
°C
Degrees (Celsius)
k kilo (value x 10
μ micro (value x 10
V Volts
Ohms
Auto Power-Off
Diode Test
)
3
)
-6
5