How To Operate The Tuner; Tuning To A Station - Fujitsu Ten ECLIPSE CD5000 Manuel D'utilisation

Operation

How to operate the tuner

ATTENTION
• If stations have been stored in memory,
pressing the stored button from [1] to [6] will
directly select a station. (Refer to "Manually
setting stations into memory" on page 29)
CAUTION
If the vehicle's battery is disconnected (for
repairs to the vehicle or for removing the
main unit), all the stations in memory will be
lost. In such a case, set stations in the
memory again.

Tuning to a station

First, press the [FM AM] button to start tuner
operation.
There are automatic and manual methods for
setting stations in memory. The main unit will
accept up to 24 stations in memory: 6 in AM 18 in
FM (6 each for FM1, FM2 and FM3). (Initial
setting)
Press the [FM AM] button for less
1
than one second to switch to the
desired FM, AM bands.
Radio bands will switch from FM1 ➔
FM2 ➔ FM3 ➔ AM in order each time
the button is pressed.
Turn the [SEL] button to the left or
2
right to tune to a station.
Turn to the right:
Tunes to higher frequencies.
Turn to the left:
Tunes to lower frequencies.
28
Press the [ ] or [
3
start the automatic station search.
button:
[ ]
Starts searching
frequencies.
button:
[ ]
Starts searching
frequencies.
ATTENTION
At times, it may be difficult to maintain optimum
reception because the antenna affixed to your
vehicle is in motion constantly (relative to the
broadcast antenna), encountering continuous
variation in the received radio signals' strength.
Other factors affecting
interference from natural obstacles, sign posts,
etc.
When an optional HD Radio tuner unit is
connected, digital broadcasts have reception
priority. (U.S.A. only)
] button to
for higher
for lower
reception include