Amibot Spirit LASER H2O Manuel D'utilisation page 27

EN
Maintenance
H2O tank
1
2
Disconnect the dust bin from the H2O tank before any maintenance.
Empty the H2O tank of any remaining water and rinse it with clean
water. Regularly check that the tank's two drip nozzles are not
obstructed by debris or limescale. Clean them with a soft cloth. Wait
until the H2O tank is completely dry before reusing it.
Open and clean the dust bin using the opening button located on the
side of it. Check that there is no dirt obstructing the robot's suction
system.
Just like the main dust bin, the 2-in-1 H2O tank is fitted with a pre-
filter (1) and a HEPA filter (2). Clean them gently by following the
steps listed in the previous paragraph.
25