Areas Of Application; Information On The Jaws; Clamping The Workpiece; Between Surfaces - Allmatic NC4 Serie Instructions De Service

ALLMATIC
8.2

Areas of Application

The NC4 is supplied with clamping jaws and is suitable for conventional clamping. The
NC8, LC and TC series clamping jaws can also be used. The clamping jaw interfaces
are identical.
8.3

Information on the Jaws

NOTICE
Incorrect screw length and too high tightening torque.
Damage to the spindle and thread breakages.
Ø Do not exceed recommended tightening torque.
Ø Only use screws of a suitable size.
Unneeded threads must be closed with screw plugs.
8.4

Clamping the Workpiece

8.4.1

Between Surfaces

Fig. 14: Clamping between surfaces
When clamping between surfaces, no material displacement takes place, i.e. the clamping
force is built up extremely quickly.
NC4
Clamping | 8
EN
57 / 376