Presetting The Speed; Set The Milling Depth; Readjust The Milling Depth; Set The Milling Depth With The Step Stop - Parkside POF 1200 A1 Instructions D'utilisation Et Consignes De Sécurité

Switching off:
Release the oN / oFF switch

Presetting the speed

Set the desired speed using the speed setting
wheel .
1
1–2 = low speed
3–4 = middle speed
5–7 = high speed

Set the milling depth

1. Ensure that the clamping lever
If it is loose turn it anti-clockwise until it is locked.
2. Place the device on the work piece to be worked
upon.
3. Turn the step stop
9
position.
4. Loosen the lock screw
5. Loosen the clamping lever
clockwise and pushing the device down until the
route bit touches the surface of the work-piece.
6. Lock the clamping lever in place
it anti-clockwise.
7. Push the depth stop
the lowest position of the step stop
the index indicator
the dial milling depth adjustment
8. Adjust the depth stop
tighten the lock screw
indicator should no longer be adjustable.
13
9. Loosen the clamping lever
device back up.

Readjust the Milling depth

The milling depth can be adjusted with the con-
trol dial .
15
Loosen the clamping lever
clockwise and pushing the device down until
the depth stop touches the step stop
12
Lock the clamping lever in place
it anti-clockwise.
.
19
is locked down.
16
until it locks into the lowest
.
11
by turning it
16
by turning
16
down until it reaches
12
. Move
9
to the position "0" on
13
.
14
to the desired depth,
12
. Afterwards the index
11
and and lead the
16
by turning it
16
9
by turning
16
Set the milling depth with the control dial
Loosen the clamping lever
clockwise and lead the device back up. Check
the milling depth through a further practical test.
Set the milling depth with the
step stop
You can use the step stop
several steps with less takeoff.
Set the desired milling depth with the lowest
step of the step stop
Then set it at higher level for the first attempt.

Milling direction

The milling process must always go against the
rotationary direction on the router bit
rotation).
ATTENTION: When milling in the direction of the
router bit (counter rotation) the device fly out of
your hand.
.
operation
.
15
by turning it
16
with deeper depths in
9
(as described above).
9
(Counter
17
GB 31