Switch Housing; Light Kit; Glass Shade - for Living 052-9336-4 Guide De L'utilisateur

8
Model No. 052-9336-4 052-9338-0
6. Attach blade assembly to motor
· If there are plastic tabs shaped like bottle caps, remove
and discard them. These are stabilizers that protect the
motor during shipping.
· Remove the screws on the bottom of the motor and use
them to attach the blade assembly to the motor. Ensure
the screws are tightened (see Fig. 11).
7. Connect switch housing
· Remove the screws from the switch housing cap and save
for use in next step (see Fig. 12).
·
Connect the wire inside the switch housing cap by snapping the
male and female connectors together. Match white wires together
and blue wire to black wire together (see Fig. 13).
8. Attach light kit
· Attach the light kit by bringing up the switch housing cap to the
fan switch housing.
· Then tightly secure the screws that were previously removed
from the switch housing cap (see Fig. 14).
9. Attach glass shade
· Unscrew the glass screw from light kit. Place the neck of glass
shade into light housing cup. Insert and tighten the glass screws
(see Fig. 15).
Motor
Screw
Screw
Switch
housing
cap
Switch
housing
cap
Screw
Switch
housing

Light kit

Screw
Glass