Preparing For Installation; Getting Ready - for Living 052-9336-4 Guide De L'utilisateur

This manual is designed to make it as easy as possible for you to assemble, install, operate and maintain
the ceiling fan. The following tools listed are required for assembly and installation:
After opening the package you should find all the necessary parts for installing this ceiling fan.
The box should also contain:
5 fan blades
5 decorative fan blade brackets
1 motor with decorative housing
1 light kit with complete installation hardware
3 glass shades
1 mounting bracket with complete installation

Preparing for installation

Getting ready

. Unpack and inspect carefully to make sure all parts are
included and not damaged (see Fig. 1). Lay all pieces out
on a working space.
Turn off power at fuse box or circuit breaker to avoid
possible electrical shock (see Fig. 2).
Choosing a location for the ceiling fan
For effective air circulation, fan should be located in the centre of the room, or a minimum of
32" (81.3 cm) from adjacent walls or obstructions.
. Choose a location where there is a high enough ceiling clearance (at least 8' 3" (2.5 m) from the
floor to the ceiling fan's lowest moving part).
. Ensure that the outlet box in the room's ceiling can support the weight of the fan. Typically, if the
outlet box is marked acceptable for fan support, it can hold the fan securely.
Installation
1. Mounting bracket
Remove the four sets of side screws from
.
mounting bracket and save for future use.
Normal masonry ceiling
.
Securely attach the mounting bracket to
an outlet box marked " Acceptable for Fan
Support ", using the supplied outlet box
screws with lock washers (see Fig. 3a).
Wooden ceiling
.
Drill two mounting holes in the ceiling
joist. Securely attach the mounting
bracket to the wooden ceiling as
indicated below (fig. 3b).
1 star-head screwdriver
1 flat screwdriver
1 wrench
Parts Pack Containing:
2 wood screws with flat washers
2 mounting screws with lock washers
1 extra blade bracket screw with spring washer
3 wire connectors
16 blade screws, flat washers and hexagon nuts
2 pull chains with fobs
1 "J" hook
1 zip tie
1
3a
3b
Mounting
bracket
wood screw
1 stepladder
1 wire stripper/pliers
1 electrical tape
2
Lock washer
Outlet box screw
Flat
washer
5