Quick Installation - Tripp-Lite SmartPro SMC1000T Manuel Du Propriétaire

Quick Installation

1
With the UPS disconnected from utility
power, use a small tool to set the
Voltage DIP Switch to match your
input voltage. (All models are preset
to the 120V setting.)
2
Plug the UPS into an outlet on a
dedicated circuit.
NOTE! after you plug the UPS into a live AC
outlet, the UPS will automatically charge its
batteries,* but will not supply power to its
outlets until it is turned ON.
* The BATTERY CHARGE LED will be the only LED
illuminated
3
Plug your equipment into the UPS.
Model SMC1500T: All outlets provide battery
backup and surge protection for computers,
monitors and other critical devices. Model
SMC1000T: Select outlets provide battery
backup and surge protection for computers,
monitors and other critical devices; select
outlets provide surge protection only for
printers and other nonessential devices.
Do not plug high-draw equipment such as
laser printers into the battery backup/
surge protection outlets.
Note: Your UPS is designed to support electronic
equipment only. You will overload the UPS if the total VA
rating for all equipment connected through the battery
backup/surge protection outlets exceeds the UPS's
Output Capacity. To find your equipment's VA ratings, look
on their nameplates. If the equipment is listed in amps,
multiply the number of amps by 120 to determine VA.
(Example: 1 amp × 120 = 120 VA). If you are unsure if
you have overloaded the UPS's outlets, see "OUTPUT
LOAD LEVEL " LED description.
4
Turn the UPS ON.
Press and hold the "STANDBY" button for one
second. The alarm will beep once briefly after
one second has passed. Release the button.
Note: UPS system will function properly upon initial
startup; however, maximum runtime for the unit's battery
will only be accessible after it has been charged for
24 hours.
14-12-046-93338B.indb 3
1
SMC1500T model shown.
2
3
4
3
12/23/2014 10:21:53 AM