Assembly Preparation - MasterCraft 068-0007-6 Guide D'utilisation

5
model no. 062-3582-8 | contact us 1-800-689-9928 model no. 068-0007-6 | contact us 1-800-689-9928

ASSEMBLY PREPARATION

• Assemble the storage cabinet on a clean, level surface.
• Remove all items from the packaging box and ensure that all parts listed on
page 3 are included.
• When installing parts that have more than one screw, tighten all screws by hand
before tightening them with the screwdriver.
Tip: A magnetic screwdriver is included for your convenience. If a power screw
driver is used, keep on a low torque setting.
WARNING
Some parts may have sharp edges. To avoid injury, wearing gloves is recommended
during assembly.
ASSEMBLY INSTRUCTIONS
1. Assemble Left Side Panel (Part 1-A)
Place Left Side Upper Panel (Part 1-A1) and Left Side Bottom Panel (Part 1-A2)
together, line up screw holes, and use three Screws G (Part 42) to connect them
(Fig. A).
Note:
Before tightening screws, make sure the corners and the touching edges of the Left Side Panel
(Part 1-A) are completely flush.
headline bars headline bars headline bars headline bars
continuation tabs continuation tabs continuation tabs continuation tabs
notes notes notes notes
warnings warnings warnings warnings
Fig. A