Stainless Steel Maintenance - MasterCraft 068-0007-6 Guide D'utilisation

11
model no. 062-3582-8 | contact us 1-800-689-9928 model no. 068-0007-6 | contact us 1-800-689-9928
13. Install Mounting Straps (Part
60)
A. Remove one Screw F (Part 41) from
each top back corner Protector. These
will no longer be needed.
B. Attach each Mounting Strap (Part
60) to the back Corner Protectors using
one Screw O (Part 61) and Washer
(Part 27).
C. Drill a hole in the wall with a 5/16"
drill bit, and insert the Wall Anchor
(Part 55-A) into the hole.
D. Attach the free ends of the Mounting
Straps (Part 60) to the wall using one
Screw M (Part 55) and Washer (Part
27-B) (Fig. M).
Warning: To prevent possible tipping, it is suggested that the Mounting Straps
(Part 60) be installed. For safety, secure the mounting straps to wood studs
whenever possible.

Stainless Steel Maintenance:

These parts have an fingerprint-resistant finish. Do not use traditional stainless
steel cleaners on this unit. Lightly wipe off once a month with clean warm water
and a soft cloth (preferably a microfibre cloth). This is the safest formula to prevent
new stains from appearing over time and manage unwanted fingerprints or grease
marks. Remember to always wipe in the direction of the surface grain (NEVER
ACROSS) and always use a lint-free cloth. Once the surface is clean, thoroughly
wipe dry with a soft, absorbent cloth.
headline bars headline bars headline bars headline bars
Fig. M
continuation tabs continuation tabs continuation tabs continuation tabs
notes notes notes notes
warnings warnings warnings warnings