Power Fist 8904120 Manuel D'utilisateur page 7

V4.0
OPERATION
IMPORTANT! Release the left clutch control lever (F) immediately when an
emergency stop is required, then press the red emergency button, then turn
the motor off. Release the emergency button by turning it in the direction
shown on the button.
Consult the engine manual for the correct procedure to start and stop
the engine.
1. Start the engine. After the engine warms up, adjust the throttle control (C)
to increase the engine speed.
2. Choose a gear with the gear selection lever (D) and slowly squeeze the
clutch control lever (F) to start moving. If the gear does not engage
straight away, slowly release the clutch lever and try again.
3. Changing direction by directly applying force to the handles. Push the
handles to the left to turn right or push the handles right to turn left. The
wheelbarrow will turn as it continues to move forward.
Travelling in reverse will have the opposite effect. You will turn in the
direction you pull.
4. When the clutch control lever is released, the machine will stop automatically.
5. Move the gear selection lever to the zero (0) to place the gear in neutral.
a. Switch the engine OFF as an additional safety precaution.
6. Dump the load by pulling the dump box release lever (E) up to release the
dump box's locking device. Manually raise the dump box to dump the load.
Lower the dump box and the locking mechanism will automatically lock the
box into place. Confirm the dump box is locked into position.
DIFFICULT TERRAIN
The power wheelbarrow may be hard to control when carrying a full load on
difficult terrain. The following steps can reduce the chance of losing control of
the equipment.
1. Reduce the power wheelbarrow's speed to low on difficult terrain such as
soft or frozen ground, on an incline or on loose gravel or stones. This will
allow more time to react to a potential loss of control.
Visit www.princessauto.com for more information
550 lb 6 cu. ft Mini Power Wheelbarrow 8904120
7