Power Fist 8904120 Manuel D'utilisateur page 10

8904120
REMOVING THE BOTTOM COVER
WARNING! Use safe lifting practices during these procedures to avoid a
back strain or other injuries.
Removing the wheelbarrow's bottom cover is necessary when repairing or
maintaining the dump box release cable or the drive chain.
1. Chock the back wheels and place the gear in neutral.
2. Pull the linch pin (#8) to free the dump box.
3. Slide the dump box off the fixed pins. Take care as the dump box weighs
50.7 lb (23 kg). Set aside.
4. Grasp the front of the chassis and lift upward so the machine rotates
around the rear tires. Lift until the handle grips touch the ground.
5. Secure the handles to the ground or support the chassis to prevent it from
falling while you work under the chassis.
6. Remove each set of screw from the four corners and set aside. Remove
the bottom screws first.
7. Pull the bottom plate (#25) and place aside.
8. Reverse these steps to reinstall the components.
DUMP BOX CABLE TENSION
1. Loosen the nut (Fig. 4-1), but do not
remove it from the bolt.
2. Pull the cable wire (Fig. 4-2) forward to
tighten or push backward to introduce
slack.
3. Tighten the nut (Fig. 4-1)
4. Complete the fine adjustment by turning
the tension nut (Fig. 4-3) clockwise to
tighten and counterclockwise to loosen.
5. Reinstall the bottom plate if no further
tasks are required.
10
550 lb 6 cu. ft Mini Power Wheelbarrow
For technical questions call 1-800-665-8685
V4.0
Fig. 4