Power Fist 8904120 Manuel D'utilisateur page 11

V4.0
REPLACING THE DRIVE BELT
1. Loosen the clutch cable. See Adjusting the Clutch.
2. Loosen the drive belt's retaining nut and ring (Fig. 5-1).
3. Remove the worn belt.
4. Loop the new belt around the drive pulley
(Fig. 5-2). Make sure the belt teeth are in
the drive pulley's groove.
5. Loop the drive belt around the engine's
pulley (Fig. 5-6) and seat in the groove.
6. Push the belt onto the tension pulley
(Fig. 5-4) and seat in the groove.
7. Adjust the clutch cable tension so the
tension pulley arm is parallel with the
machine's front (Fig. 5-3).
8. Tighten cable. See Adjusting the Clutch
9. Reinstall the bottom plate if no further tasks are required.
ADJUSTING THE DRIVE CHAIN
1. Loosen the nuts (Fig. 6-1) on each side of the rear axle.
2. Adjust the axle position until the chain on
each side is tight. Make sure the axle is
square with the chassis.
3. Check that the cog's teeth on each wheel
lines up with the chain links.
4. Tighten the nuts to secure the axle in place.
5. Reinstall the bottom plate if no further tasks are required.
CLEANING
Never use a pressure washer to clean the power wheelbarrow. Water can
penetrate tight areas of the machine or its gearbox case and damage the
spindles, gears, bearings or the engine. This can shorten the equipment's
operational life and reduce serviceability.
Visit www.princessauto.com for more information
550 lb 6 cu. ft Mini Power Wheelbarrow 8904120
Fig. 5
Fig. 6
11