Adjusting The Clutch - Ultraflex B 501 CH/B Manuel D'installation Et D'entretien

ULTRAFLEX
5 Engage the rod (20) on the pin (21).
7 Fix the cable inserting the circlip (E) in the
groove of the pin (21).

3.6 Adjusting the clutch

Both the control boxes B501 and B502 allow the adjustment of the clutch.
NOTICE
For Control B502 with trim (CHT/BT, CHTL/BTL) DUE TO THE COMPLEX dismounting operations the cluth
adjstment is not reccomended.
Follow the instructions below:
1 CONTROL B501: Remove the plastic cover
(7) (if already placed).
6 Remount the cable
fastener (8) on the plate
(9) aligning the cable
cylinder (11) with the
hole of the cable
20
fastener.
Fix the cable fastener
to the plate with the
screws (10).
For CONTROL B502
21
tighten screw M5 (17)
aligning the cable
cylinder to the holes of
the cable fastener.
NOTICE
For push
throttle, connect the
cable rod on the pin
E
(21A) and insert the
cable cylinder into
21
the plate hole (16A).
1 CONTROL B502: Remove the right lever hub
plug (1), unscrew the hexagonal head screw (2)
with a 17 socket wrench and extract the right lever
(3).
7
SINGLE LEVER CONTROL B501 AND B502
Installation and maintenance manual
9
11
10
action
21A
16A
2
page 13
-
8
3
1
of 71