Jandy Pro Series ePump Serie Manuel D'installation Et D'utilisation page 20

Page 20
ENGLISH
Figure 12. Remove the Diffuser, Regal Beloit Motor
Diffuser O-ring
Diffuser Screws
and Washers (2)
Figure 14. Diffuser and Impeller Exploded View
Carbon Seal Surface
• Ceramic Face Seal
• Backplate Seal
Figure 15. Mechanical Seal
Jandy Pro Series ePump™ Series Pump | Installation and Operation Manual
®
Backplate
Diffuser
Backplate
Screws (2)
Diffuser
Diffuser O-Ring
Washers (2)
Diffuser
Self Sealing
Left Handed
Mechanical
Screw
Seal
• Carbon Face/ Spring
Side of Seal
• Impeller Side of
Mechanical Seal
Fan
Figure 13. Remove the Impeller, Regal Beloit Motor
Backplate
Impeller
O-ring
Backplate
6.2.2.1 Impeller Reassembly
1. Press the new carbon face seal half (see
Figure 15) on the motor shaft using a twisting
motion. Make sure the carbon surface is facing
toward the ceramic ring in the backplate.
Very Important! To prevent damage to the seal,
grasp the lower portion of the seal (opposite the
carbon face) when installing it.
NOTE To assist assembly, use only water or soapy
water as a lubricant. Any other lubricant will
destroy the seal after a short period of time.
Mechanical
Seal
Impeller
Self Sealing
Left Handed
Backplate
Washers (8)
Bolts (8)
CAUTION
Screw