Getting Started - auna Areal Bar Connect Mode D'emploi

EN
40

GETTING STARTED

Battery installation (remote control)
Battery installation(Battery not included):
1. Press the tab on the battery door and lift it off.
2. Install two (2) x AAA size batteries into the battery compartment as the
figure on right and the polarity markings inside battery compartment.
3. Replace the battery door.
Follow these precautions when using a battery in this device:
• Use only the size and type of battery specified.
• Besure to follow the correct polarity when installing the battery as
indicated in the battery compartment. A reversed battery may cause
damage to the device. batteries to prevent damage or injury from
possible battery leakage.
• Do not dispose of battery in fire. Battery may explode or leakage.
• Clean the battery contacts and also those of the device prior to battery
installation.
• Do not mix different types of batteries together (e.g. Alkazline and
Carbon-zinc) or old batteries with fresh ones.
• If the batteries in the device are consumed or the device is not to be
used for a long period of time, remove the
• Do not try to recharge the battery not intended to be recharged; it can
overheat and rupture.