Power Linking; Fuse Replacement; Mounting Diagram - Chauvet DJ Intimidator Wave IRC Manuel De Référence

Intimidator Wave IRC QRG EN
Intimidator Wave IRC has an auto-ranging power supply that can work with an
AC Power
input voltage range of 100–240 VAC, 50/60 Hz.
To eliminate wear and improve its lifespan, during periods of non-use
completely disconnect from power via breaker or by unplugging it.

Power Linking

Power linking describes products that are daisy chained together through their
Power In and Power Out sockets so that many products are powered from one
outlet. For the maximum number of Intimidator Wave IRCs that can be power
linked at 120 V or at 240 V, see the User Manual or the label on the product.
The User Manual is available at the Chauvet website:
http://www.chauvetlighting.com.

Fuse Replacement

1. Disconnect the product from power.
2. With a Phillips #2 head screwdriver, unscrew the fuse holder
cap from the housing.
3. Remove the blown fuse.
4. Replace with a fuse of the same type and rating.
5. Screw the fuse holder cap back in place and reconnect power.
Disconnect the product from power before replacing the fuse.
Mounting Before mounting this product, read the Safety Notes. Use one or two mounting
points and one safety cable per product. Make sure the mounting clamps (such as
CLP-15 clamps from Chauvet) are capable of supporting the weight of the
product. For the Chauvet line of mounting clamps, go to the Chauvet website at
https://www.chauvetdj.com/products/category/accessories/.
Mounting Clamps
Safety
Cable
Hanging/Mounting
Bracket
Rubber
Feet (x4)

Mounting Diagram

When using only one mounting clamp with this fixture, you must use a clamp
with a captive bolt to prevent accidental loosening.
4